Setting Up The St50 Snow Thrower - Quadivator ST50 Assembly/Operators/Parts Manual

4. Setting up the ST50 Snow Thrower

.1Remove the ST50 Snow Thrower from the shipping box:
1. The ST50 Impeller Housing Assembly
2. The ST50 Drive Belt – Part # 89513
3. The ST50 Discharge Chute & Spout Assembly
4. The ST50 Discharge Chute Crank Mechanism
5. ST50 Belt Tension and hardware package
.2 Set the ST50 Impeller housing on a smooth level surface for assembly!
.3 Attach the Discharge Chute & Spout Assembly to the Impeller Housing
with the 4 attaching sliders and hardware – as shown!
.4 Attach the ST50 Discharge Chute Crank Mechanism – with two bolts
attached!
Attach the chute to the
Housing with the sliders
and hardware provided!
Attach the chute adjuster to
the Housing with the
hardware provided!
Adjust the chute for smooth
operation by centering chute
to housing and then
installing the chute crank
mechanism.