Quadivator ST50 Assembly/Operators/Parts Manual page 16

Step 4
– Attach the belt tension springs (2) from the adjust arm to the frame
above it.
Step 5
– Attach the winch to the hole on the frame provided
NOTE
– the initial lifting of the ST50 by winch should be done very cautiously,
the winch should "bottom" on the winch hook – before the ST50 contacts the ATV
front frame or the ATV itself.
mounted hole as shown in illustration below.
Use the chain provided to loop through the
.
The ST50 with winch
attached in attaching hole.
The ST50 with winch
attached through the
extended winch attach hole -
extended with looped chain
– to allow winch hook to
bottom on the winch, prior to
the ST50 contacting the ATV
or the ATV's front
bumper/tubing!
NOTE – be very cautious with
the first use of the winch to
raise the ST50.