Quadivator ST50 Assembly/Operators/Parts Manual page 15

5
.
Initial Mounting of the Quadivator ST50 to an ATV
NB - General Principles for mounting the Snow Thrower to ATV,
requires an electric winch to lift the unit during transport).
1. Mounting Power Unit
2. The ST50 is attached to the Interframe with pins provided.
3. Belt is attached and tensioned.
4. Winch is attached to the hook location and lifted.
5. Snow Thrower is adjusted side to side.
This initial fit up – Quadivator ST50 to ATV - should take place on a flat hard
surface that has enough room to mount the thrower to the ATV, and then
manoeuvre the assembled unit!
Step 1
– Please refer to the Power Unit manual for instructions on mounting the
PU/Interframe to ATV
Step 2 –
Attach the ATV to the ST50 with the two pins at the forward ends of the
Interframe.
Step 3 –
Attach the belt to the front drive pulley – RHS of belt (from the driver's
position) goes to bottom of the pulley to the front, over the top, through the idler
to the left side of the Interframe back to the upper pulley on the Interframe
Springs (2) shown in place
providing belt tension – from
the pulley adjust to the
frame.
Belt shown in place, RHS of
belt (from the driver's
position) goes to bottom of
the pulley to the front, over
the top, through the idler to
the left side of the Interframe
back to the engine drive.
The ST50 attached to the
Interframe with attaching
hardware.
(the ST50