Configure The Parameters Of The Acquisition Config Window - Data Translation DT9828 User Manual

Chapter 4
4. Under the Sensor column, select the sensor type for the channel.
5. Under the Engineering Units column, Deg C is selected by default. If you want to change
6. If you know the offset for your calibrated thermocouple, enter it under the EU Offset
7. Leave the test point values for each channel unchanged.
8. Click Close to close the Channel Configuration dialog box.

Configure the Parameters of the Acquisition Config Window

For this example, set the Acquisition Config parameters as follows:
1. Click the Recording tab.
2. For Filename, enter a meaningful name for the data file.
46
For this example, set the sensor type for analog input channel 0 to Type J and the sensor type for
analog input channel 1 to Type T.
this setting, change the temperature units under the Acquisition Config - Acquisition
tab.
In this example, Deg C is used.
column.
For this example, leave 0 as the EU offset for the thermocouple.
In this example, LogData.hpf is used.