Data Translation DT9828 User Manual page 28

Chapter 2
4. For Windows Vista:
5. Repeat these steps until you have attached the number of hubs and modules that you
Host Computer
Note: You can unplug a module, and then plug it in again, if you wish, without causing
damage. This process is called hot-swapping.
Your application may take a few seconds to recognize a module once it is plugged back in.
28
a. Click Locate and install driver software (recommended).
The popup message "Windows needs your permission to continue" appears.
b. Click Continue.
The Windows Security dialog box appears.
c. Click Install this driver software anyway.
For Windows XP:
a. Click Next and/or Finish as required in the wizard.
Once the firmware is loaded, the wizard restarts to initiate the firmware to accept commands.
b. Click Next and/or Finish again.
Note: Windows 7 and Windows 8 find the device automatically.
desire. Refer to Figure 4.
The operating system automatically detects the USB devices as they are installed.
DT9828 Module
USB Cable
Power Supply
for Hub
DT9828 Module
Figure 4: Attaching Multiple Modules Using Expansion Hubs
DT9828 Module
USB Cables
USB Cable
Self-Powered
USB Hubs
DT9828 Module
USB Cables