Camranger Hardware - CamRanger User Manual

CamRanger Hardware
The CamRanger device is turned on by sliding
the power switch, located on the side of the
unit, towards the front of the device. The
green power light will illuminate when the unit
is powered on. Any switch on the opposite
side of the power switch does not currently
have any func5onality.
The charging port is located next to the power
switch. The male micro B end of the provided
white charging cord is connected to this port.
The other end of the charging cord can be
connected to a female USB port that provides power, such as a computer or through the
provided AC adapter.
When the device is charging an addiLonal yellow light will illuminate next to the green power
light indicaLng that it is charging. The yellow light will turn off leaving only the green power light
when it is fully charged.
A black neoprene case is provided to assist in aOaching and securing the CamRanger. The case
has a carabineer to facilitate hanging from a tripod, belt loop, etc. Do not just hang the
CamRanger by the cable as it will put strain on the USB connectors as well as possibly
disconnect.
The CamRanger baOery is accessible by removing the boOom cover.
The boOom cover is the side with the CamRanger serial number. Simply grasp the side edge/
corner of the cover near the USB connector and pull back to remove. To replace the cover, first
place the two lower tabs into the slots and then snap in the top.
CamRanger is not water-resistant in any way and should not get wet.
© CamRanger – Patent Pending 4