Camranger Setup; Firmware Update - CamRanger User Manual

Enter the 8-character CamRanger serial number. The serial number is located both on the
boOom of the back cover as well as above the baOery underneath the back cover. Note: the
serial number contains only leOers and NO numbers.
Press the "Register" buOon to register. A message box will appear indicaLng registraLon was
successful and the iOS device can be used with the CamRanger. Exit the app and then proceed
with the setup process as detailed below in the CamRanger Setup secLon.
If registraLon fails, confirm Internet connecLvity and the CamRanger serial number before
contacLng contact@CamRanger.com for assistance.
CamRanger Setup
Power on the CamRanger and confirm that all four lights briefly appear. The CamRanger will
take approximately 30 seconds unLl it is fully iniLalized.
The first Lme the user connects to CamRanger from an iOS device (iPad, iPhone, or iPod Touch),
the iOS device needs to be registered. See the CamRanger RegistraLon secLon above.
On the iOS device connect to your CamRanger network. The SSID will be CamRanger-###, with
the last three characters matching the last 3 characters of the CamRanger's serial number. The
password is the full 8 characters of the CamRanger's serial number. The password MUST BE
ENTERED IN ALL CAPS. The keyboard on newer iOS versions can be put into caps lock by double
tapping the shif key.
Connect the CamRanger to the camera with the provided black USB cable. The male A end is
inserted into the USB port at the end of the CamRanger, and the other end is connected to the
USB port of the camera. Then ensure the camera is turned on. When the camera is connected
and turned on the green light closest to the edge of the CamRanger device will light.
Launch the CamRanger iOS app. The applicaLon will connect to the CamRanger and the user
will be able to control the camera.
For common problems with setup and connecLon refer to the TroubleshooLng secLon at the
end of the manual.
Firmware Update
It is recommended to check the iOS app and firmware version before using the CamRanger to
ensure they are the latest version. The app must be at least 2.0 and the firmware version 6 to
support network bridging, sharing features, or the CamRanger PT Hub and MP-360 (or MP 101,
Bescor, or Hague). To update the CamRanger firmware, visit camranger.com/downloads for
further instrucLons on update.
To check the CamRanger app and firmware version, refer to the 'Help' tab within the
CamRanger sejngs. The iniLal digits listed afer CamRanger indicate the app version and the
© CamRanger – Patent Pending 6