Camranger Hardware - CamRanger User Manual

CamRanger Hardware
The CamRanger device is turned on by sliding the
power switch, located on the side of the unit,
towards the front of the device. The green power
light will illuminate when the unit is powered on.
Any addi0onal switch present on the CamRanger
currently serves no func0on.
The charging port is located next to the power
switch. The male micro B end of the provided
white charging cord is connected to this port. The
other end of the charging cord can be connected to a female USB port that provides power,
such as a computer or through the provided AC adapter.
When the device is charging, an addiIonal yellow light will illuminate next to the green power
light indicaIng that it is charging. The yellow light will turn off leaving only the green power light
when it is fully charged.
The CamRanger baKery is accessible by removing the boKom cover. The boKom cover is the
side with the CamRanger serial number. Simply grasp the side edge/corner of the cover near the
USB connector and pull back to remove. To replace the cover, first place the two lower tabs into
the slots and then snap in the top.
CamRanger is not water-resistant in any way and should not get wet.
A black neoprene case is provided to assist in aKaching and securing the CamRanger, note that
this pouch is not waterproof. The case has a carabineer to facilitate hanging from a tripod, belt
loop, etc. Do not just hang the CamRanger by the cable as it will put strain on the USB
connectors as well as possibly disconnect.
3
© CamRanger – Patent Pending