Scan Setting - TechniSat DIGITRADIO 110 IR Instruction Manual

3. To manually change the FM frequency, while FM frequency shows up, press
the frequency by 0.05MHz.
4. To automatically scan, while FM frequency shows up, press
button, your radio will skip forwards or backwards until it reached the next available station.

9.2 Scan setting

By default, FM scans stop at any available station. This may result in a poor signal-to-noise ratio (hiss) from
weak stations.
1. To change the scan settings to stop only at stations with good signal strength, press MENU button, press
or button to select 'Scan setting', and then press OK button to confirm.
2. Display will show 'Strong stations only', press
confirm.
9.3 Audio Settings
By default, all stereo stations are reproduced in stereo. For weak stations, this may result in a poor signal-to-
noise ratio (hiss).
1. To play weak stations in mono, press MENU button, press
then press OK button to confirm.
2. Display will show 'Listen in Mono only?' Press
confirm.
9.4 Storing Preset Stations
Your radio can store up to 10 of your favourite FM stations. This will enable you to access your favourite stations
quickly and easily.
1. While playing your favourite station, press and hold one of Preset buttons 1-10 until display shows
'Preset stored'.
2. Preset number ' #' will show on the display.
or button and then press the SCAN
or button to select 'YES' and then press OK button to
or button to select 'Audio setting', and
or button to select 'YES', and then press OK button to
or button to change
EN
FR
IT
NL
PL
CZ
SK
33