Carrier 30GTN Installation Instructions Manual page 7

Configure Control (All Sizes)
1. The control must be configured to recognize the
Energy Management Module. Using the display, press
until the screen is blank. Use the arrow keys to
ESCAPE
select the Configuration mode LED. Follow the steps
outlined in Table 1 using the keys on the display.
2. To change the value of EMM, press
Marquee display screen is blank. Use the arrow keys to
light up the Configuration mode LED. Press
Press the down arrow key until OPT1 is displayed.
MODE KEYPAD
(RED LED) ENTRY
CONFIGURATION
ENTER
until the
ESCAPE
.
ENTER
Table 1 — Configuration Mode Menu
KEYPAD
SUBMODE ITEM
ENTRY
DISP
UNIT
OPT1 FLUD
ENTER
HGB.S
HPCM
HPCT
PRTS
PMP.1
CPC
CA.UN
CB.UN
EMM
Press . Press the up arrow key to select
ENTER
EMM. Press
ENTER
value, NO. Press
will be displayed. Press
default password of 1111. Press
confirm the password. Use the arrow keys as needed if
the password is other than 1111. The NO value will
now be flashing. Press the up arrow key
the value to YES and
DISPLAY ITEM EXPANSION
X COOLER FLUID
HOT GAS BYPASS
YES/NO
SELECT
HEAD PRESS.
X
CONT. METHOD
HEAD PRESS.
X
CONTROL TYPE
PRESSURE
YES/NO
TRANSDUCERS
COOLER PUMP
ON/OFF
INTERLOCK
COOLER PUMP
ON/OFF
CONTROL
NO. CIRCUIT A
X
UNLOADERS
NO. CIRCUIT B
X
UNLOADERS
EMM MODULE
YES/NO
INSTALLED
7
to stop display at its current
again and PASS WORD
ENTER
to bring up the
ENTER
four times to
ENTER
to change
to accept the change.
ENTER
COMMENTS
Default: No
Change to Yes