Table of Contents
Advertisement
S9 – Carrier Detect Response Time
Sets the time that the carrier must be present before a connection is established.
Default 6 {1..255} (1/10 sec).
S10 – Lost Carrier To Hang Up Delay
Sets the length of time that the modem waits before hanging up after a loss of carrier.
When register S10 is set to 255, the modem functions as if a carrier were always present.
Default 14 {1..255}(1/10 sec).
S11 – DTMF tone time
The time a DTMF tone will be activated during dialling.
Default 95 {50..255} (1/1000 sec).
S12 – Escape Prompt Delay (EPD)
Time before entry/exit of command mode (+++).
Default 50 {0..255}(1/50 sec).
S14 – General Bit Mapped Options Status (Read only register)
Bit Interval
0
1
2
3
4
5
6
7
6178-2203
Default
Description
–
0..1
0..1
0..1
0..1
0..1
0..1
0..1
Reserved
0
1
Command echo:
0-Echo Disabled (ATE0)
1-Echo Enabled (ATE1)
Result Codes:
0
0-Send Result Codes (ATQ0)
1-Do Not Send Result Codes (ATQ1)
Result Code Control:
1
0-Numeric (ATV0)
1-Verbose (ATV1)
Reserved
0
Tone/Pulse:
0
0-Tone
1-Pulse
(Please also refer to Dn – Dial
Command p. 17)
Reserved
0
Originate/Answer:
1
0-Answer
1-Originate
37
Advertisement
Table of Contents
