Table of Contents
Advertisement
•
CAM_5 :
Config #α : 1 x CAM 8 bits (720p)
: 1 x CAM 8 bits (720p)
Config #β : 1 x SDIO interface (SD XC compatible)
: 1 x SDIO interface (SD XC compatible)
In summary, all option s are below
s are below :
•
LCD 24 bits (1080p) + 3xCAM 8 bits (720p)
LCD 24 bits (1080p) + 3xCAM 8 bits (720p)
•
LCD 24 bits (1080p) + LCD 8 bits (720p) + 2xCAM 8 bits (720p)
LCD 24 bits (1080p) + LCD 8 bits (720p) + 2xCAM 8 bits (720p)
•
LCD 24 bits (1080p) + CAM 16 bits (1080p) + CAM 8 bits (720p)
LCD 24 bits (1080p) + CAM 16 bits (1080p) +
•
LCD 16 bits (1080p) + 4 x CAM 8 bits (720p)
LCD 16 bits (1080p) + 4 x CAM 8 bits (720p)
•
LCD 16 bits (1080p) + CAM 16 bits (1080p) + 2 x CAM 8 bits (720p)
LCD 16 bits (1080p) + CAM 16 bits (1080p) + 2 x CAM 8 bits (720p)
•
LCD 16 bits (1080p) + LCD 8 bits (720p) + 3 x CAM 8 bits (720p)
LCD 16 bits (1080p) + LCD 8 bits (720p) + 3 x CAM 8 bits (720p)
•
LCD 8 bits (720p) + 5 x CAM 8 bits (720p)
LCD 8 bits (720p) + 5 x CAM 8 bits (720p)
•
LCD 8 bits (720p) + C
LCD 8 bits (720p) + C AM 16 bits (1080p) + 3 x CAM 8 bits (720p)
•
LCD 8 bits (720p) + LCD 8 bits (720p) + 4 x CAM8 bits (720p)
LCD 8 bits (720p) + LCD 8 bits (720p) + 4 x CAM8 bits (720p)
•
6 x CAM 8 bits (720p)
6 x CAM 8 bits (720p)
•
CAM 16 bits (1080p) + 4 x CAM 8 bits (720p)
CAM 16 bits (1080p) + 4 x CAM 8 bits (720p)
5.3.12 IO configuration
The GPIO interface provides programmable general input/output conf
provides programmable general input/output configurable. Interrupt lines
available on any edge or polarity event. Each source can be selected among all the GPIOs.
available on any edge or polarity event. Each source can be selected among all the GPIOs.
available on any edge or polarity event. Each source can be selected among all the GPIOs.
Each pads have programmable :
•
Drive strength : can be programmed from 2.93mA to 17.24mA during pull
: can be programmed from 2.93mA to 17.24mA during pull -up and
: can be programmed from 2.93mA to 17.24mA during pull
16.17mA during pull down .
•
Slew Rate : The slew rate is defined as the maximum rate of change of the out
: The slew rate is defined as the maximum rate of change of the out put voltage.
: The slew rate is defined as the maximum rate of change of the out
•
Keeper : enable or disable keeper mode. Holds last value on a tri
: enable or disable keeper mode. Holds last value on a tri - state bus.
•
Pull-down or Pull-up : active an internal pull
Parameter
Pull Up impedance
Pull Down impedance
•
Schmitt trigger : enable or disable Schmitt Trigger.
: enable or disable Schmitt Trigger.
ITU 656
CAM _5
CAM
8 bits
.
: active an internal pull -down or pull-up.
Min.
Confidential Information
Config #α
Config #β
8 bits
igurable. Interrupt lines
state bus.
Typ
Max.
27
30
34
27
30
34
Ref: OEM-2012-149
2.68mA to
Unit
kOhm
KOhm
30/39
Advertisement
Table of Contents
