Teradek Cube 605 Manual

A
B
C
D
E
F
G
A: Wi−Fi Antenna G: OLED display
B: Video input status H: Stream Joystick
C: Encoder status I: Menu Joystick
D: Broadcast status J: SD/HD/3G−SDI and HDMI inputs
E: SD/MMC Card slot K: 10/100/1000 Ethernet
F: Fault/Error L: Reset button
Stream Joystick:
: Access quick menu actions, exit menu screens
(button press)
●
Menu Joystick:
, , , : Select menu items, change status screen on main display, select characters
▲ ▼
: Confirm selection, open selected menu
● (button press)
Reset Button:
Hold for 3−6 seconds: Reset all network settings
Hold for 10+ seconds: Perform complete factory reset
NEED MORE HELP?
1. Support: http://support.teradek.com → Contains tips, information and all the latest firmware & software updates.
TERADEK SUPPORT STAFF: support@teradek.com or call 888−941−2111 ext2 (Mon−Fri 9am to 6pm PST)
600 series
J
K L
M
N
O
P
J
H
I
M: Power Switch
N: Power Input
O: 1/8" Headphone output
P: Mic/Line stereo input
Q: USB Port
PHYSICAL CONNECTIONS
Connect power to Cube using the included A/C adapter or one of the available accessory power cables
1
A
(see Teradek.com).
Connect the SDI or HDMI output from your video source to one of Cube's video input connectors (J).
2
CONNECT TO CUBE
Cube has a built in web interface for configuring stream destinations, encoder parameters,
Q
and other settings. The interface can be accessed by connecting via Wi−Fi or wired Ethernet.
WI−FI
Connect to Cube's Wi−Fi network: Teranet−XXXXX (serial number of the device).
1
Open a web browser and navigate to http://172.16.1.1, or find Cube using Bonjour.
2
Cube's Wi−Fi can be configured to join your network via the web UI or front panel.
3
CONNECT TO A WIRED NETWORK
Plug an Ethernet cable into Cube's 10/100/1000 Ethernet port and connect it to an Ethernet switch
1
or router.
Connect your computer to the same network. Cube's IP address is displayed on the front panel's Ethernet
2
Status menu, access it by pressing down on the Menu joystick to cycle through status screens.
Open a web browser and navigate to Cube's IP address, or find Cube using Bonjour.
3
STREAM TO THE INTERNET
Open Cube's web UI, Select the Video Stream Output menu if it is not already displayed.
1
Select Internet Streaming as the Stream Mode and choose a platform − Facebook, Ustream, Livestream,
2
YouTube, Twitch − or select manual RTMP.
Enter your credentials and choose a channel/event, or enter the RTMP destination info and press apply.
3
Select your desired Audio/Video bitrate and resolution under the Encoder menu.
4
5
Go Live by clicking the Broadcast button
NEED MORE HELP?
1. Support: http://support.teradek.com → Contains tips, information and all the latest firmware & software updates.
TERADEK SUPPORT STAFF: support@teradek.com or call 888−941−2111 ext2 (Mon−Fri 9am to 6pm PST)
, or use the front panel Stream Joystick
1
2
3