Table of Contents
Advertisement
3-2
Transfer Rail Width Adjustment
TAKE CARE NOT TO PINCH YOUR HANDS OR FINGERS.
You will have serious injury if your hands or fingers are caught in the conveyors during
manual (or automatic) width adjustment.
M09E
BEFORE PERFORMING AUTOMATIC WIDTH ADJUSTMENT, BE SURE TO
VERIFY NO BOARDS OR OTHER OBJECTS ARE ON THE CONVEYOR.
Boards or other objects may drop from the conveyor, causing damage to the boards or
the machine.
If there are any boards or other objects on the conveyor, turn OFF the servo switch and remove them.
M36E
When the board gets small (the width of transfer rail gets narrow), take out sup-
port pins of board holder before carrying out the rail width adjustment. If it is
failed to take out pins, the sensor to prevent the contact of support pins and con-
veyor works, and the automatic operation stops, as "Supporter and conveyor
error" is detected.
According to data of board size and thickness, the rail width of the left and right transfer conveyors
and board holder is automatically adjusted.
To the next page
293C-E-EMA03-A01-02
WARNING
CAUTION
NOTICE
1
. Press
.
Machine
adjust
3
Page 3-5
Advertisement
Table of Contents
