Table of Contents
Advertisement
3-1
Changing the Production Data
This section describes loading data from PT as an example. To load data from PT, two ways of "a)
Transferring from PT to this machine" and "b) Loading by the file operation" are available.
• To load data of the floppy disk, see "Chapter 6 File Operation."
∗ Loading data to use deletes data used by now. To store data used by now, save it.
See "Chapter 5 Teaching" for carrying out the board recognition, bad mark, and
dispensing recognition teaching.
a) Transferring from PT to this machine
Page 3-2
NOTICE
1.
Display the main menu screen and
send data of the production board to
change from PT.
∗ See "PROGRAMMING MANUAL" for sending
data from PT.
• Sending data from PT changes the data name
on the right of screen to the sent one.
293C-E-EMA03-A01-01
Advertisement
Table of Contents
