Table of Contents
Advertisement
Using the water circulation method for temperature control
The water circulation method used for the temperature control for the nozzle holder, always keeps
the adhesion of bond steady, regardless of the change of surrounding temperature.
Temperature
control unit
Nozzle stroke and speed can be optionally set
As the nozzle stroke and speed can be optionally set, stable dispensing without threading is
available.
The nozzle speed can be set at either of high, middle, and low speed.
1-1-3
Improved Operating Efficiency
Reducing the time for arrangement and adjustment
As the nozzle can be removed and set easily, syringes and nozzles are changeable in short time.
Also, as the next syringe is arranged during the production by the handle valve for taking out the
air, the arrangement and adjustment time in supplying and changing the materials are reduced.
General machine (BD12S-MR)
Syringe
Joint
Tube
Nozzle
Holder ring
293C-030E
Changing time
Setting
: 180 s
Taking out air
: 120 s
Adjusting height : 300 s
293C-E-EMA01-A01-02
Temperature
Temperature indicator
setting panel
39.0
FUNC
ENT
Button setting
M3 bolt
Putting nozzles together
Parts : 5 pieces
Total of 600 s
Characteristics of Machine
10°C to 50 °C (per 0.1°C)
POWER
ON
OFF
293C-029E
BD30S-M
Syringe
293C-031E
Changing time
Setting
: 20 s
Taking out air
: 0 s∗
Adjusting height : Unnecessary
∗ For taking the air out for arrangement
Nozzle
Parts : one piece
Total of 20 s
Page 1-3
1
Advertisement
Table of Contents
