Table of Contents
Advertisement
2-2
Functions during Production Stop
These are functions to carry out the immediate stop during production.
(The immediate stop is to stop the production shortly during the sequence.)
DO NOT PLACE YOUR HANDS OR BODY INSIDE ACTIVE PART OF THE MA-
CHINE WHEN IT IS IN A SINGLE STOP OR CYCLE STOP CONDITION.
The machine has been stopped only temporarily. You may be injured if the sensors are
actuated and the machine moves unexpectedly.
Turn OFF the servo switch before placing your hands or body inside the active part.
M34EB
293C-JEn-PrPr-001
START
STOP
Page 2-6
WARNING
UNLOCK
STEP
SELECT
KEY LOCK
KEY LOCK
STOP
1
. Press
for the immediate stop
on the operation panel.
∗ To restart the operation, press
• The machine state independent of the produc-
tion data is set.
See "Chapter 8 Machine Settings."
• The production information starts.
• The operator mode appears.
• The remained counter is checked and reset.
• The maintenance during the automatic opera-
tion is carried out.
• The head is restricted.
• The primary dispensing starts.
(Only with the function switch turned on.)
• Data requiring the correction after teaching and
the coordinate data can be corrected.
See "Chapter 4 Data Modification."
UNLOCK
START
and
.
293C-E-EMA02-A01-01
Advertisement
Table of Contents
