Compacting; Shutting Down - Weber mt CR 9 CCD 2.0 Operating And Maintenance Manual

Compacting

Use the rocker switch (1) to control the drive speed.
Only run machine within reach (2) of the manual
guidance rod.
Pressing the impact plate (1) will automatically
switch the machine into forward motion in the direc-
tion of travel.
The green LED (1) will be illuminated as soon as the
operating frequency has been reached, indicating that
the COMPATROL compaction measurement system
®
is ready for operation.
During the compaction work compaction is continuously
measured and displayed visually via the yellow LEDs 1 – 7
(2). Maximum possible compaction is reached as soon as
there is no noticeable increase in the illuminated LEDs.

Shutting down

Bring the gas lever (1) into idle position (pull towards the
operator).
Turn the ignition key (1) from position "1" to position "0".
Pull out the ignition key.
Close the vandalism flap (1) and lock with a padlock.
During breaks – even if they are short – the machine
must be shut down.
Parked devices that represent an obstacle must
be safeguarded against through conspicuous
measures.
CR 9 CCD 2.0
1
2
1
2
1
1
1
1
17