Slowly tighten the handle (1) of the reversing starter (2)
until resistance is noticeable.
Allow the handle (1) to glide back into the initial position,
and then forcefully and completely pull it through with both
hands.
After the engine has warmed up, slide the choke lever
to the right (open).
Compacting
Bring the gas lever (1) into full-throttle position
Control drive speed and direction of travel with the handle (2).
Only run machine within reach of the manual
guidance rod.
Shutting down
Bring the gas lever into idle position.
Close the fuel cock (1).
Turn the short-circuit button (1) to the "0" – OFF position.
Completely empty the water tank if there might be
a frost.
During breaks – even if they are short – the machine
must be shut down.
Parked devices that represent an obstacle must be
safeguarded against through conspicuous measures.
16
.
2
1
2
1
1
1
CR 1_CR 2R