Compacting - Weber mt CR 8 Operating And Maintenance Manual

Insert the ignition key (1) and turn to position 1.
Turn the ignition key (1) to position 2.
Release the ignition key as soon as the engine starts.
The ignition key must bounce back to pos. 1 and remain
in this position during operation. The charge level indi-
cator (4) and the oil pressure indicator (3) must go out
immediately after starting.
The indicator lamp (2) lights up, indicating that the engine is
in operation.
The operating hours counter (5) will keep counting the operat-
ing hours as long as the ignition is switched on.
If the ignition key does not bounce back to pos. 1 – turn
off the machine immediately – danger of starter damage
due to the starter also running during operation.
Start for a maximum of twenty seconds without interrup-
tion. If the engine does not start, repeat starting process
after a minute. If the motor does not start after two start
processes, seek cause in fault table.
After turning on the ignition, you will be shown the time
remaining until the next maintenance inspection in field
5 for 10 s.

Compacting

Control drive speed and direction of travel with the handle (1).
Only run machine within reach of the manual guidance
rod.
14
5
2
3
1
4
1
CR 8