Advertisement
LED-P10
UNDERWATER LIGHT OPERATING MANUAL
Voltage: AC 12V
Keep this manual for future reference
This underwater light must be installed by a licensed or certified electrician in
accordance with the National Electrical Code and all applicable local
codes and ordinances. Improper installation will create an electrical hazard
which could result in death or serious injury to pool users, installer, or others
due to electrical shock, and may also cause damage to property. Read and
follow the specific instructions below.
Before installing this underwater light, read and follow all warning notices and
instructions accompanying this light. Failure to follow safety warnings and
instructions can result in severe injury, death, or property damage.
Attention Installer.
This manual contains important information about the installation, operation
and safe use of this product. This information should be given to the owner
/operator of this equipment.
Installation instructions
1)T his underwater lights mounted to the trial in the 2 "PVC pipe
Metric 1.25Mpa),before installation,selecting a suitable PVC pipe.(Note:
Due to a variety of different wall thickness PVC pipe, please refer to Figure 1
to choose appropriate size of tube)
2) To ensure pool electrical systems compliance with national act requires,
before installation. Electrical system must be made by the official figuren
licensed electrician or qualifies electrician to install.
3) Underwater lamp circuit requires leakage protection socket and breaker.
4) 2 "PVC pipe installation with complete swimming pool flat surface,
Frequency: 50/60Hz Power: 1W
DANGER
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION
WARNING
IMPORTANT NOTICE
1-2
(Imperial 12Bar,
EMLI15031471
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for emaux LED-P10
Summary of Contents for emaux LED-P10
- Page 1 LED-P10 UNDERWATER LIGHT OPERATING MANUAL Voltage: AC 12V Frequency: 50/60Hz Power: 1W Keep this manual for future reference DANGER RISK OF ELECTRICAL SHOCK OR ELECTROCUTION This underwater light must be installed by a licensed or certified electrician in accordance with the National Electrical Code and all applicable local codes and ordinances.
- Page 2 underwater lights installed and the water surface distance between 40cm- 70cm. (Figure 2) 5) When installing underwater lights, be parpare long enough cable(Min 1m) to ensure that maintenance and replacement lamp can be out of the water. (Figure 3) 6) When installing underwater lights, Please refer to Figure 4 and Figure 5 of the lamp into the PVC pipe.
Need help?
Do you have a question about the LED-P10 and is the answer not in the manual?
Questions and answers