emaux UL-TP100 Series Operating Procedures

WARNING
Never operate this pool lamp for more than 10 seconds unless it is totally submerged in water. Without total
submersion, the lamp assembly will get extremely hot, which may result in serious injury to pool users,
installers, or bystanders, or in damage to property.
Be sure power is off before installing or removing lamp. Allow lamp to cool before relamping. This light
fixture uses a Halogen Quartz lamp. Do Not touch lamp with bare hand, this may severely reduce its life.
Use the plastic furnished with the replacement lamp to eliminate finger prints pin from the bulb.
lFor use only when immersed in water, IP68
lFor operation only with approved safety isolating transformer: Input:230V Output: 12V~ 75VA
lThe safety isolating transformer must meet the EN61558-2-6 standard
lSELV, the safety source shall be installed outside of Zone 0, 1 and 2
If you want to replacement the lamp, loosen the screw of back cover, open the back cover and replace
the lamp, and carefully fixed gasket seal, re-tightening the screw. The replacement takes place from the
side of the luminaires in contact with the water but after the water of the pool has been partially or
completely drained.
CAUTION: Never try to repair or replace the lamp by yourself. If this underwater light fixture is out of
working, it shall be repaired or replaced by the manufacturer or his service agent or similarly qualified
persons in order to avoid a hazard.
CAUTION: The transparent plastic Protective Shield can not be replaced, if the Protective Shield is cracked,
this underwater light fixture shall be scrapped.
REPLACEMENT PARTS
Key
Part No. Description
No.
Colour lens (Red+Green+Blue)
1* 01221003
for P100, DP100
2 01051059 Face Plate for TP100
3 03011307 M4*12 Screw
4 01040211 Lights Lens
5 02021055 O-Ring for TP100
Halogen high Bulb (Yellow
6 04011002
Light)
7 89040402 UL-TP100 Lights Body Set
8 03011331 M4*12 Screw
9 03011332 M4*16 Screw
10 01012005 TP100 Lights Bracket
11 89040401 TP100 Lights Vinyl Pool Fitting
TP100 Lights Concrete Pool
12 89040501
Fitting
Note:* UL-TP100 Light Colour Lens 1 set (Red+Green+Blue)
Qty
1
1
1
1
1
1
1
8
2
1
1
1
4-4
UL-TP100 Series Underwater Light
Operating Procedures
Please read the following carefully and
keep this user manual save for future reference
DANGER !
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION
This underwater light fixture must be installed by a licensed or certified electrician or a
qualified serviceman in accordance to the requirements of your government standard or
local authorities. Improper installation will create electric hazards which could result in
serious injury, death as well as damage to the property. Before servicing the light,
disconnect the power supply from the circuit breaker. Failure to do so could result in serious
injury, death and or damage to the property.
1-4
English
EMLI16022767