Johnson Level & Tool 1760-2400 Quick Start Manual

1760 Series Digital Levels Quick Start Guide (1760-2400 • 1760-4800)
Thank you for purchasing this Johnson digital level! This level helps
you accurately determine plumb, level or any angle in between -
perfect for building ramps, setting drainage pitches and more!
This digital level features:
• Accuracy of 0.10° (at 0°/90°)
• Accuracy of 0.20° for all other angles
• Reads in units of in/ft, mm/m, degrees and percent
• Angled backlit display for easy reading
• IP54 dust and water resistance
• Hold and reference modes
LCD SCREEN & BUTTON OVERVIEW
LEVEL INDICATORS (2)
SOUND INDICATOR
HOLD INDICATOR (2)
MAIN
DISPLAY
Powers on/off the level
Enables/disables sound
Sets the temporary zero reference
Changes the displayed unit or auto shutoff timer
Enables/disables the backlight
Freezes the current screen reading
Initiates calibration mode
BATTERY INDICATOR
UNIT DISPLAY (2)
REFERENCE
INDICATOR (2)
We want to get you up and running as quickly as possible - but this quick start guide is not a replacement for reading and understanding your
operator's manual! For complete safety & operating instructions, refer to the operator's manual included with your tool or scan the QR code.
INSTALLING THE BATTERIES
1. Always use fresh batteries (2xAAA).
2. Use a #1 Philips screwdriver to remove the battery cover.
3. Insert the battery according to the polarity indicated on the level
and in the diagram below.
4. Replace the cover - do not over-tighten the screw.

GETTING STARTED

1. Insert fresh batteries - see "INSTALLING THE BATTERIES".
2. For best results, calibrate your level prior to each use. See
"CALIBRATION PROCEDURE" for details.
3. Power on the digital level by pressing
4. Enable or disable sound by pressing
5. Set your operating units by pressing
6. Enable the backlight by pressing
automatically turn off after 30 seconds of inactivity. Press any
button or move the level to re-enable the backlight.
7. Set the desired auto shutoff timer by pressing and holding
The LCD will indicate "5" for 5 minutes or "2H" for 2 hours.
8. Set a temporary zero reference by pressing
ZERO REFERENCE". To exit reference mode, press
9. To hold a measurement, press
press again.
10. During operation, the level indicators will show which direction
the digital level must be tilted to achieve a reading of zero:
Move Left Side Up
11. The audio alert will increase in speed as you approach closer to
zero, and turn into a solid tone when you have achieved zero.
12. To power off the level, press
.
.
.
. The backlight will
. See "SETTING A
. To return to normal operation,
On Grade Move Right Side Up
.
www.johnsonlevel.com/manuals
.
again.