Saeco Incanto HD8911 User Manual page 32

English
32
Problem
The coffee has too
little crema or is
watery.
Coffee is leaking from
the coffee dispensing
spout.
The coffee is not hot
enough.
The machine grinds
the coffee beans, but
coffee does not come
out.
The coffee exit duct is
blocked.
The coffee comes out
slowly.
The frothed milk is too
cold.
Cause
The grinder is set to a too coarse
setting.
You are using an unsuitable
coffee blend.
The machine is performing its
self-adjustment.
The brew group is dirty.
The coffee dispensing spout is
clogged.
The cups you use are cold.
The temperature is set too low.
Check the menu settings.
You added milk.
The coffee exit duct is blocked.
The grind is set to a too fine
setting.
The brew group is dirty.
The coffee dispensing spout is
dirty.
The coffee is grind too finely.
The brew group is dirty.
The coffee exit duct is blocked.
The machine circuit is blocked
by limescale.
The cups are cold.
Solution
Adjust the grinder to a finer
setting.
Start using a different coffee
blend.
Brew a few cups of coffee.
Clean the brew group.
Clean the coffee dispensing
spout and its holes with a pipe
cleaner.
Preheat the cups by rinsing
them with hot water.
Set the temperature to 'high' in
the menu.
Whether the milk you add
is warm or cold, it always
decreases the temperature of
the coffee to some extent.
Clean the coffee exit duct
with the handle of the
multifunctional tool or a spoon
handle.
Adjust the grinder to a coarser
setting.
Clean the brew group.
Clean the coffee dispensing
spout and its holes with a pipe
cleaner.
Use a different coffee blend or
adjust the grinder.
Clean the brew group.
Clean the coffee exit duct
with the handle of the
multifunctional tool or a spoon
handle.
Descale the machine.
Preheat the cups by rinsing
them with hot water.