Adjustments And Operation; Hints For Mounting The Transmitter; Transmitter Operation; Receiver Operation - Hunter Rain-Clik Owner's Manual & Installation Instructions

Adjustments and Operation

Hints for Mounting the Transmitter

• Choose a location such as the side of a building or post.
The closer the transmitter is to the receiver, the better
the reception. Do not exceed 800' (275 m).
• To ensure maximum range in communication, mount
the receiver and transmitter away from sources
of electrical interference (e.g., control panels,
transformers, etc.) or metal objects. Best performance
is obtained when no physical obstruction is between
the transmitter and receiver.
• Correct placement of the Wireless Rain/Freeze-Clik®
model is important for accurate temperature sensing.
The best location would be out of direct sunlight.
• The reset rate refers to the amount of time it takes
for the sensor to dry out sufficiently for the sprinkler
system to be allowed to come back on. The mounting
location will affect this rate. For example, mounting
the transmitter in a very sunny location may cause
the sensor to dry out sooner than desired. Similarly,
mounting the sensor in constant shade may keep the
sensor from drying out sooner.

Transmitter Operation

There is nothing to set up with the Wireless Rain-Clik.
12

Receiver Operation

The receiver has two LED lights that indicate the state of
the system.
1. SENSOR STATUS LED:
RED
– Sensor is wet (watering
disabled)
GREEN – Sensor is dry
(watering enabled)
YELLOW – Sensor is in
addressing mode
2. SENSOR BYPASS LED:
RED
– Rain sensor is bypassed (even though the sensor
is bypassed, the STATUS LED will continue to alert you
of the state of the sensor — wet or dry)
OFF – Rain sensor is enabled
FLASHING RED – Indicates that communication
between the transmitter and receiver was lost
Note:
When you first apply power to the receiver,
the SENSOR STATUS LED will be RED. Press
the manual test spindle on the transmitter
for five seconds and release the spindle. The
SENSOR STATUS LED will turn GREEN indicating
proper operation.
SENSOR BYPASS Red light indicates
sensor is bypassed
SENSOR STATUS GREEN = Sensor is dry
RED = Sensor is wet
Press to bypass, press
again to re-enable
RAIN SENSOR BYPASS