Mounting The Receiver; Wiring The Receiver To A Hunter X-Core®, Pro-C®, Pcc, Icc2, Or I-Core; Wiring The Receiver To A Hunter Acc Or Acc2 - Hunter Rain-Clik Owner's Manual & Installation Instructions

Mounting the Receiver

Wiring the Receiver to a Hunter X-Core®, Pro-C®,
PCC, ICC2, or I-Core®
1. Remove the sensor jumper across the two SEN
terminals in the controller.
2. Attach the two yellow wires to the 24 VAC terminals.
3. Attach the blue wire to one SEN terminal and the white
wire to the other SEN terminal.
SENSOR BYPASS Red light indicates
sensor is bypassed
GREEN = Sensor is dry
SENSOR STATUS
RED = Sensor is wet
Press to bypass, press
again to re-enable
RAIN SENSOR BYPASS
8
C
P MV
B
SEN
W
SEN
TEST
REM
Y
AC
Y
AC
G
O
Not used

Wiring the Receiver to a Hunter ACC or ACC2

1. Connect the blue and white wire to any of the four
Sensor Terminal pairs (Sen 1 shown).
2. Attach yellow wires to 24 VAC and COM terminals.
3. Use features at the "Set Sensor Operation" dial position
on ACC to complete setup.
4. Use Devices and Sensor Response options
on ACC2 to complete setup.
5. See ACC/ACC2 owner's manuals for
further details.