Wiring The Receiver To A Hydrawise; Tm -Enabled; Controller; Wiring The Receiver To Other Controllers: Normally Closed Sensor Applications - Hunter Rain-Clik Owner's Manual & Installation Instructions

Wiring the Receiver to a Hydrawise

Controller

1. Attach the two yellow wires to the 24 VAC terminals.
2. Attach the blue wire to one SEN terminal and the white
wire to the SEN COM terminal.
Wiring the Receiver to Other Controllers: Normally
Closed Sensor Applications
3. Attach the two yellow wires to the 24 VAC terminals.
4. Attach the blue and white wires to the sensor terminals
(if available) or in-line with the valve common wire.
-Enabled
TM
SENSOR BYPASS Red light indicates
sensor is bypassed
AC AC GND SEN
GREEN = Sensor is dry
SENSOR STATUS
RED = Sensor is wet
Press to bypass, press
again to re-enable
RAIN SENSOR BYPASS
W
B
Y
Y
O
SENSOR BYPASS Red light indicates
sensor is bypassed
C P MV AC AC
GREEN = Sensor is dry
SENSOR STATUS
RED = Sensor is wet
Press to bypass, press
again to re-enable
RAIN SENSOR BYPASS
W
B
Y
Y
O
Mounting the Receiver
SEN
COM SEN
Common wire
to all valves
Used for normally
open sensor
applications
Common wire
to all valves
Used for normally
open sensor
applications
9