Home Depot FC132-BJRL Use And Care Manual page 9

Assembly -Hanging the Fan (continued)
5
Making the electrical connections
WARNING: To avoid possible electrical shock, ensure the electricity is
turned off at the main fuse box before wiring.
WARNING: To avoid possible electrical shock, ensure the electricity is
turned off at the circuit breaker or main fuse box before wiring.
WARNING: Check to see that all connections are tight,including the
ground, and that no bare wire is visible at the wire nuts, except for the
ground wire.
NOTE: Cut the extra wire, if you feel the excess wire too long,
then follow the step connet wire.
Insert the receiver (J) into the mounting bracket (A)with the at side of
the receiver (J) facing the ceiling.
Follow the steps below to connect the fan to your house
supply wires. Secure the wire nuts supplied with your fan by
wrapping the connections with electrical tape.
□
Motor to Receiver Electrical Connections:
Connect the ORANGE wire from the fan to the ORANGE wire marked
"Light +" from the Receiver.
Connect the BLUE wire from the fan to the BLUE wire marked "Light -"
from the Receiver.
Connect the YELLOW wire from the fan to the YELLOW wire marked" V"
from the Receiver.
Connect the RED wire from the fan to the RED wire marked" U" from the
Receiver.
Connect the GREY wire from the fan to the GREY wire marked" W" from
the Receiver.
Note: Fan must be installed from a maximum distance of 40 feet from the
transmitting unit for proper signal transmission between the transmitting unit
and the fan's receiving unit.
□
Receiver to House Supply Wires Electrical connections:Connect the WHITE
wire(Neutral) from the outlet box to the WHITE wire marked " POWER N"
from the Receiver.Connect the BLACK wire(Hot) from the outlet box to the
BLACK wire marker " POWER L" from the Receiver.
□
If your outlet box has a GROUND wire (Green or Bare
Copper),connect this wire to the Hanger Ball and Hanger
Bracket and receiver Ground wires.If your outlet box does not
have a Ground Wire, then connect the Hanger Ball and Hanger
Bracket and Receiver Ground Wire together.
□
Secure wire connection with the plastic P2 wire nuts(JJ) provided.
□
After all splices are made, check to make sure there are no loose strands.
9
Item # 1000*****/1000*****
Item # FC132-BJRL/FC140-BJRL