Home Depot FC132-BJRL Use And Care Manual page 8

Assembly - Hanging the Fan
3
Attaching the fan to the electrical box
WARNING: To reduce the risk of re, electric shock, or other personal
injury, mount the fan to an outlet box or supporting system marked
acceptable for fan support and use the mounting screws provided with
the outlet box.
□
Pass the 120-Volt supply wires through the center hole in the
mounting bracket (A).
□
Install the ceiling mounting plate on the outlet box by the
mounting bracket (A) over the two screws (AA) provided with the
outlet box (M) . If necessary, use leveling washers (not included) be
tween the mounting bracket (A) and the outlet box. Note that the
at side of the mounting bracket(A)is toward the outlet box.
□
Securely tighten the two mounting screws (AA).
4
Hanging the fan
WARNING:The hook (XX) is only to balance the fan while
may result in the hook (XX) breaking, causing the fan to
fall. The hook must pass from the inside to the outside of
the canopy.
WARNING:When hanging the fan on the hook (XX) it is
critical that you use one of the non-slotted (round) holes
in the canopy (C).
□
Carefully lift the fan-motor assembly (F) up to the slide-on
mounting bracket (A).
□
Insert the ball portion of the ball/downrod assembly into
the socket of the slide-on mounting bracket (A).
□
Turn the ball/downrod assembly clockwise until it is seated
with the tab of the slide-on mounting bracket (A) aligned
with the slot in the ball.
-
8
Item # 1000*****/1000*****
Item # FC132-BJRL/FC140-BJRL
F