Table Of Contents - Lectrosonics DBa Instruction Manual

Table of Contents

Introduction ............................................................................ 4
Battery Installation ................................................................ 6
Belt Clips ................................................................................ 7
Operating Instructions .......................................................... 7
Powering On in Operating Mode .......................................... 8
Powering On in Standby Mode ............................................ 8
Powering Off ........................................................................ 8
Power Menu Options ............................................................. 8
Entering the Power Menu ..................................................... 8
LCD Menu Map ....................................................................... 9
Main Menu and Setup Screen Details ................................ 10
Entering the Main Menu ..................................................... 10
Main Window Indicators ..................................................... 10
Connecting the Signal Source ........................................... 10
Adjusting the Input Gain ..................................................... 10
Selecting Frequency .......................................................... 11
Selecting Programmable Switch Functions........................ 11
Selecting the Low Frequency Roll-off ................................ 11
Selecting Audio Polarity (Phase) ........................................ 11
Selecting Battery Type ....................................................... 11
BatTime .............................................................................. 11
Locking/Unlocking Changes to Settings............................. 12
Restoring Default Settings ................................................ 12
Wipekey ............................................................................. 12
Whip Antennas .................................................................... 12
Encryption Key and Settings Transfer ............................... 12
Accessories ......................................................................... 13
5-Pin Input Jack Wiring ....................................................... 14
Microphone Cable Termination
for Non-Lectrosonics Microphones ............................ 15
Input Jack Wiring for Different Sources ............................ 16
Compatible Wiring for Both Servo Bias Inputs
and Earlier Transmitters: .................................................... 16
Simple Wiring for Servo Bias Inputs ONLY: ........................ 16
Microphone RF Bypassing ................................................. 17
Line Level Signals .............................................................. 17
Firmware Update ................................................................. 18
Troubleshooting ................................................................... 20
Specifications and Features ............................................... 21
Service and Repair .............................................................. 22
Returning Units for Repair ................................................. 22
Consumer Alert for US Users - FCC Order DA 10-92
Most users do not need a license to operate this wireless microphone system. Nevertheless, operating this micro-
phone system without a license is subject to certain restrictions: the system may not cause harmful interference; it
must operate at a low power level (not in excess of 50 milliwatts); and it has no protection from interference received
from any other device. Purchasers should also be aware that the FCC is currently evaluating use of wireless mi-
crophone systems, and these rules are subject to change. For more information, call the FCC at 1-888- CALL-FCC
(TTY: 1-888-TELL-FCC) or visit the FCC's wireless microphone website at www.fcc.gov/cgb/wirelessmicrophones.
To operate wireless microphone systems at power greater than 50mW, you must qualify as a Part 74 user and be
licensed. If you qualify and wish to apply for a license go to: http://www.fcc.gov/Forms/Form601/601.html
Rio Rancho, NM
Digital Hybrid Wireless Belt-Pack Transmitter
3