Chapter 3: Operating Mode Skin 2 - Max Skin 2 Instruction Manual

3 OPeRATInG MOde SKIn 2
GIVe adjustment screw of needle intensity
You have the possibility to adjust the strength
of the needle throw (GIVE). This adjustment
allows to set the machine "harder" adapted for
lining or "softer" adapted for colouring, filling
and shading. The adjustment notches on the
cap of the GIVE allow intermediate set ups.
N.B.
The machine comes with Liner Setting, the adjustment screw
is tightened completely and the smallest notch on the cap matches
with the reference notch on the machine frame. It is recommended
to not fully tighten the screw GIVE but leave always 2 or 3
notches unscrewed and put there the smallest notch on the cap.
If the machine does not run the screw GIVE is too tightened,
unscrew a little bit.
Shader Setting (soft)
By turning the cap anti-clockwise, the adjustment screw of the needle throw
GIVE is loosened and the setting becomes softer, more you loosen the screw,
more the machine setting becomes SOFTER. It is possible to loosen the screw
up to 2 complete rotations (2 times 360°). N. B. Never loosen the screw more
than 2 complete rotations or the mechanism will disassemble.
Liner Setting (hard)
By turning the cap clockwise, the adjustment screw of the needle throw GIVE
is tightened and the setting becomes harder, more you fix the screw, more the
machine setting becomes HARDER. ATTENTION: Do not overtighten, do not
force to screw over the limit.