Advertisement
Installation (Continued)
4. Using your fi ngers, insert the supplied Push Retainer
through the rubber seal, protector, and hood (Fig. 3).
Push the fastener fi rmly into the hole until it is fully
engaged and sits fl ush. (Fig. 4).
5. Repeat this step for the remaining 3 holes.
PRESS FIRMLY!!
6. Properly locate the protector and ensure:
a. The protector is seated in contours.
b. The protector is centered side to side.
c. The holes in the protector are aligned with
holes into hood.
7. Close hood.
8. Locate the tape liner fl ag for the lower (leading)
edge of part. (Fig. 5; Flag 1 in Fig 6) Slowly remove
tape liner along the length of the part. (Fig. 6)
NOTE: For proper installation, the lower leading
edge tape liner MUST be removed fi rst!
The leading edge tape liner must be removed
from the back of the part (trailing edge) due to the
mechanical fasteners installed under the hood,
(reference Fig. 3).
12/29/11
Sheet Metal
3
Trailing Edge
2
End
1
Leading Edge
Page 2 of 4
Protector
Fastener
Rubber Seal
Fig. 3
Fig. 4
Fig. 5
1
2
3
Fig. 6
Rev-0
Advertisement
