Moving Operation (Same Direction) - Kustom Signals Directional Golden Eagle II Operator's Manual

Section 7—System Operation

7.4 MOVING OPERATION (SAME DIRECTION)

1. Place the Directional Golden Eagle II in the moving
mode of operation by depressing the MODE switch until
reaching the moving mode as observed by the road
graphic indicators. Select SAME operation by
depressing the SAME/OPP switch on the remote
control. Verify that the road graphic indicators for same
direction are lit. Select the desired antenna.
Select
Moving
MODE
2. While driving, observe traffic traveling the same
direction as the patrol vehicle. Ensure fan interference
filter is set to desired state (see Sec. 7.1 Step 7).
Complete a tracking history of the target vehicle as in
Sec. 7.2 Step 3. Verify the patrol speed-reading with the
patrol vehicle's speedometer. If all agree, enforcement
action may be taken.
NOTE: If an incorrect patrol speed is obtained, the operator
can go in and out of HOLD quickly. This will
clear all previous speeds, and a new patrol speed
search will be initiated.
NOTE: The minimum difference in speed between the
patrol vehicle and the target vehicle is 3 mph (5
km/h).
3. The Directional Golden Eagle II can automatically detect
whether the strongest target vehicle is traveling slower
or faster than the patrol vehicle. There is no need for the
operator to input slower or faster information for same-
direction targets.
4. Refer to Sec. 7.3, steps 5-7 for locking of the target
vehicle's speed.
__________________________________________________
Select
Same
Direction
SAME
OPP
7.12
or
Select
Antenna
FRNT
REAR