Jxbc57 Kit For Outdoor Remote Blower Locations - Monogram ZVB36 Installation Instructions Manual

The blower and motor assembly can be
mounted on an outside wall. This kit provides
a means to mount the blower outside with a
protective cover.
1
• Separate the cover from the base assembly
Step
• Check to be sure all parts are present.
Check
Parts
Supplied
20
by removing 5 screws. Retain screws.
Cover
Junction Box
JXBC57 Kit
For Outdoor Remote Blower Locations
Materials Required
(not supplied)
• Approved liquid tight service connections for use
between the wire compartment on the base and inside
the structure.
• 7 wire nuts or other approved connectors.
• Six 5/16" dia. fasteners compatible with the type of
material the base is being fastened to.
• 3-1/4" x 10" to 6" round transition.
• 3-1/4 x 10" duct, (or 6" round) sufficient length to reach
the outdoor installation location.
• Electrical cable and connectors, sufficient length to
connect the downdraft vent to the remote blower
location. 14-guage min. is recommended, must
conform to local codes.
Tools required:
• Pencil or chalk
• Measuring tape
• Drill with appropriate bits
• Phillips head screwdriver
• 1/4" Nut driver
• Wire nuts
• Safely glasses
Package of screws
Cover Plate
Base
Assembly
Outlet Pan
Damper
Outlet Plate