Step 3, Install Raise/Lower Switch - Monogram ZVB36 Installation Instructions Manual

3
WARNING: Disconnect electrical power from
unit before beginning switch installation.
Step
Failure to do so could result in personal
injury or damage to the electrical controls.
Install
Determine the location for the RAISE/
Raise/Lower
LOWER switch. The wiring lead is 72" long.
Switch
• Drill a 3/16" hole into the desired location.
– If switch is mounted into a tile surface, drill
• Center the mounting bracket over the hole
• Mount the metal switch bracket with screws
• Tie a knot in the lead as close to the switch
• Thread the wire lead through the hole in
• Pull wire through hole from underside of
• Peal film from the back of the switch trim to
• Press trim onto the mounting bracket to set
• Peal film from the back of the RAISE/
• Remove protective coating from the top of
Important: Do not connect wire leads to white
connector until you have threaded the lead
through the countertop hole and through the
end of the wire box.
• Push wire metal leads into the white connec-
• Place plastic strain relief over wire, the wire
• Push the strain relief into the hole on the
• Secure wire box to vent with screws
• Coil the excess wire and position away from
the hole between tiles. Use locally approved
caulking to cover any gaps.
and mark pilot holes. Remove and drill pilot
holes.
(not provided, choose screws for your type
of countertop or use locally approved
adhesive).
as possible. This will prevent the lead from
being pulled away from the switch.
the top of the countertop.
countertop and thread the wire lead into
the end of the wire box.
expose the adhesive.
the adhesive.
LOWER pad to expose adhesive. Align with
impression and press to set adhesive.
the trim frame.
tor plug. Pull wire through box leaving
about 2" additional length. See illustration.
should be flat and fit into the area. Do not
pinch or twist the wire. Snap the strain relief
closed.
wire box. It will snap into position.
provided.
moving parts and cabinet contents.
Installation
Downdraf t Vent Systems
Knot
3/16" Hole
2 Pin Connector
Pull 2" Length
Out of Box
Trim
Mounting
Bracket
Thread Electrical
Leads Through Hole
Leads
Strain
Relief
15