Faults; Troubleshooting - Panduit CP-881 Operation Manual

© Panduit Corp. 2018

FAULTS

When operating faults occur, trouble-shooting depends on different fault conditions. After
recognizing the fault condition, trouble-shooting can be carried out by the following points.
Fault Condition 1
Cable cannot be inserted.
Fault Condition 2
Crimping has not been completed.
Fault Condition 3
Crimping is completed.
Cable cannot be pulled out.
Fault Condition 4
Cable insulation is not completely removed.
Fault Condition 5
The ferrule is not separated from band.
Fault Condition 6
Counter related fault, CP-881 does not work.
Fault Condition 7
The CP-881 works tool slow, but counter works.
Fault Condition 8
Crimp stamp or crimp forging die is defective.

TROUBLESHOOTING

Fault Condition 1:
Cable cannot be inserted
o Cable can only be inserted
in start position (front) and
not in maintenance
position (rear).
o Press the reverse button
(1) to move the CP-881
into start position.
PA26958A01_10 ENG
OPERATION MANUAL
Diagram 19: Move the CP-881 into start position
Page: 19 of 28
CP-881 ENG
4-2018