CT-260
CRIMPING TOOL
OPERATION INSTRUCTIONS
WIRE CUTTER for No. 10 AWG and
smaller copper wire.
CRIMP
POCKETS
for
insulated and non-insulated terminals,
disconnects, wire joints and splices on No.
22 to 10 AWG solid or stranded wire.
This tool is made of hardened steel and is
protected with a light coat of oil.
NON-INSULATED
CRIMP POCKET
INSULATED
CRIMP POCKET
NON-INSULATED AND INSULATED
PARALLEL SPLICE
INSTRUCTIONS
1. Insert stripped wire into each end of the
parallel splice. (See product packaging
for proper strip lengths.)
2. Locate parallel splice in proper crimp
pocket.
3. Position crimp pocket on the center of
the metal barrel.
4. Squeeze handles firmly.
E-mail:
techsupport@panduit.com
CT-260
OPERATION INSTRUCTIONS
© Panduit Corp. 2014
See product packaging or contact Customer Service for
Pan-Term
www.panduit.com
Page: 1 of 2
CAUTION:
Verify power is "OFF" before working on wiring with this tool.
The plastic grips are for the user's comfort,
and are not intended to insulate against electrical shock
while working on live electrical circuits.
UL/CSA approved tooling/product combination.
REV.: 02 5-2014
CRIMP POCKET
NON-INSULATED BUTT SPLICE
INSTRUCTIONS
1. Insert stripped wire into end of the butt
splice to internal wire stop. (See product
packaging for proper strip lengths.)
2. Locate butt splice in proper non-
insulated crimp pocket.
3. Position crimp pocket on the center of
the metal barrel half with wire inserted.
4. Squeeze handles firmly.
5. Repeat for other end of butt splice.
CRIMP POCKET
INSULATED BUTT SPLICE
INSTRUCTIONS
1. Insert stripped wire into end of the butt
splice to internal wire stop. (See product
packaging for proper strip lengths.)
2. Locate butt splice in proper insulated
crimp pocket.
3. Position crimp pocket on the center of
the metal barrel half with wire inserted.
4. Squeeze handles firmly.
5. Close insulation if desired.
6. Repeat for other end of butt splice.
For Technical Support:
1-888-506-5400, ext. 83255
PA24429A01