General Safety Requirements - Prem-I-Air EH1413 User Manual

GENERAL SAFETY REQUIREMENTS

Domestic wiring must be tested periodically by a qualified electrician at least
once every 10 years or at every change of occupancy. For office and retail
premises, and buildings such as village halls, the wiring must be inspected at
least once every 5 years.
It is recommended that all building be fitted with smoke alarms (it is mandatory
for new buildings).
If the remote control is to be used, install two AAA batteries into the battery
compartment, ensuring the correct polarity.
Plug the mains lead into a 13 Amp mains socket.
If connecting via an extension lead, make sure that the lead is rated at 13 Amps
or more, and that it is fully unwound.
Switch the appliance on at the mains socket.
Remote
Swing
Sensor
On/Off
Press the "1/0" button to start the appliance
Select the mode by pressing the "MODE" button. The available modes are:
AUTO: Automatic mode: selects the optimum fan speed to maintain the
•
selected room temperature.
HI/MED/LO: Selects high, medium or Low fan speed.
•
o
DEHUM: Dehumidifier setting; in this mode there is no cooling and the
•
fan speed is selected automatically.
FAN: Fan only mode with no cooling.
•
AUTO SWING: Selects up and down movement of the louvers.
THERMO CONTROL: The default temperature setting is 25°C, use these buttons
to select the desired room temperature (16°C - 30°C). When the temperature
reaches the desired figure the compressor will stop and the unit will operate as
fan only till the temperature rises sufficiently for the compressor to restart.
2836
INSTALLATION AND OPERATION
Timer
Set Buttons
Window
Set the required room temperature using the THERMO
CONTROL buttons. The set temperature is displayed on the
LED display. Cooling modes only.
LED
Temperature
Display
Controls
4
Mode On/Off
Button Button
Ver. 2 - 04/14