Safety And Emc Instructions; Installation - AccuLine TNplus 1000m User Manual

1. Safety and EMC Instructions

Please read carefully the following user manual and the
safety instructions before installing or operating the unit!

1.1 Installation

See installation instructions before connecting to mains power.
Condensation may occur if the UPS is moving directly from a cold
to a warm environment. The UPS must be absolutely dry before
being installed. It is recommended to have an acclimatization time
of at least two hours.
Do not install the UPS near water or in a damp environment.
Do not install the UPS where it would be exposed to direct sunlight
or near heat.
Do not connect appliances or items of equipment which would
overload the UPS (e.g. laser printers, etc.) to the UPS output.
Place cables properly to avoid having someone treaded or tripped
over them.
Make sure that the UPS is reliably connected to the earth.
Connect the UPS only to a socket outlet which is earthed
shockproof type.
The building wiring socket outlet (shockproof socket outlet) must
be easily accessible and close to the UPS.
With the installation of the equipment, the sum of the leakage
current of the UPS and the connected load does not exceed
3.5mA.
Do not block ventilation openings on the UPS housing. Ensure the
air vents on the front, side and rear of the UPS are not blocked. It is
recommended that you provide at least 25cm of free space on
each side of the UPS. The air flow diagram is shown as below:
-1-