Setting By The Lcd Module - AccuLine TNplus 1000m User Manual

7. Setting by the LCD Module

The output voltage/frequency, Auto bypass status, operating mode in No
output mode or Bypass mode, charger current, external Battery Pack
Number or Capacity (Ah) and battery remaining time function in all modes
can be set directly via the LCD module.
In bypass or no output mode, press the Enter button on the LCD panel for
more than 1 second to enter the setting mode. The LCD display is shown in
the following figure 7.1. The string OPV stands for output voltage and
230Vac indicates that the existing output voltage is 230Vac. if you want to
set the output voltage, press the Enter button for more than 1 second, a
flickering string 220Vac will be shown, if the Enter button is pressed
again, the string 220Vac will remain permanently lit and the output voltage
will change to 220V; if the Select button is pressed for more than 1 second,
the next flickering string 230Vac will appear. The order of voltage values to
select from is 220 230 240. Press the Enter button to confirm the
output voltage what you want.
Figure 7.1 Setting by LCD
To exit the setting mode press the Enter button once;to continue setting,
press the Select button. If there is no use of the Select or Enter
more than 10 seconds, you will automatically exit the setting mode.
While in the setting mode, the output frequency string OPF , Bypass status
string bYPA , operating mode string MOdE , External Battery Pack
Number string EbPN , battery remaining time string bATT , Charger
current string CHG will be presented circularly
-24-