Button - AccuLine TNplus 1000m User Manual

4.1 Button

Switch Function
ON/Silence
Turn on the UPS:
Button
By pressing the ON-Button continuously for more than 1 second the
UPS system will be turned on.
Deactivate acoustic alarm:
By pressing this Button during battery mode an acoustic alarm can
be deactivated.
By short touching this Button, any acoustic alarms can be
deactivated during any modes.
Perform the battery test:
By pressing this Button the UPS will perform the battery test while in
Line mode or ECO mode or CVCF mode.
OFF
When mains power is normal, the UPS system switches to No
Button
output or Bypass mode by pressing the OFF-
inverter is off. At this moment, if Bypass is enabled, then the output
sockets are supplied with voltage via the bypass if the mains power
is available.
Deactivate acoustic alarm:
By pressing this Button during Bypass mode an acoustic alarm can
be deactivated.
Release the UPS from fault mode and EPO status.
Select
The output voltage, frequency, Bypass disable/enable and operating
Button
mode in No output or Bypass mode, External Battery pack number
or capacity (Ah)*, Battery remaining time display disable/enable and
Enter
the charging current in all modes, can be selected by pressing
Button
Select-Button, and confirmed by pressing Enter-Button.
*Note: By default, users can set the
changed via the software so that users will be able to configure the External Battery
Capacity (Ah) via the LCD settings
External Battery pack number. This can be
-9-