Technical Data; Electrical Specifications - AccuLine TNplus 1000m User Manual

batteries. If there is a battery breaker then turn it off first. Disconnect the
battery cable carefully and make sure that there are no exposed wires
that can be touched. Reconnect the new batteries to the UPS by
following the instructions in section 5.2. Then turn on the battery
breaker and press the ON switch to set the UPS in performing battery
test. Check whether the battery information are normal.

10. Technical Data

10.1 Electrical specifications

TNplus. 1000m
Phase
Frequency
Voltage
Current(A)
4.9/4.7/4.5 5.7/5.4/5.2 9.7/9.3/8.9 9.7/9.3/8.9
TNplus
Power rating*
Voltage
Frequency
Wave form
*Note: the active power is defined in rated voltage input
TNplus. 1000m
Voltage 24V
Capacity 9Ah
*Note:
1. the Capacity of the external batteries can be set to 300Ah maximum but it is
strongly recommended not to exceed the 120Ah.
2. For the standard models 1000m / 2000m / 3000m / 3000m PRO the capacity
should not be set over 30Ah.
INPUT
1000Lm 2000m
45-55 / 54-66 Hz
220/230/240VAC
OUTPUT
1000(L)m
1kVA/0.9kW
220Vac/230Vac/240Vac
BATTERIES
1000Lm 2000m
24V 48V
5Ah~120Ah* 9Ah
-32-
3000m /
2000Lm
3000m PRO
Single
14.5/13.9/13.3 14.5/13.9/13.3
2000(L)m
2kVA/1.8kW
50/60Hz
sinusoidal
2000Lm
48V
5Ah~120Ah*
3000Lm
3000(L)m (PRO)
3kVA/2.7kW
3000m
3000Lm
(PRO)
72V 72V
9Ah 5Ah~120Ah*