Cleaning & Maintenance; User Replaceable Parts - Grindmaster OPOD Manual

Cleaning & Maintenance
Cleaning the Unit
NOTE: When cleaning the unit, do not use cleansers, liquid bleach, powders
or any other substance that contains chlorine. These products promote
corrosion of plastic parts. Use of these products will void the warranty.
1. Empty the drip tray as needed and wash in a solution of dish detergent.
2. Wipe exterior of brewer with a soft, damp cloth. Do not use abrasives
which will scratch the surface. Do not immerse machine in water.
Descaling the Water Reservoir and Hot Water Tank
1. Fill the water reservoir one fourth full with white vinegar, then fill the rest
of the way with clean tap water.
2. Place a 12 ounce (355 ml) cup on the drip tray to catch cleaning solution.
3. Activate the momentary prime switch next to the power switch on the back
of the machine until approximately 10 ounces (296 ml) has been dispensed.
4. Repeat step (3) four more times.
5. Let machine operate until the heating lamp is solid green (not flashing).
6. Wait 10 minutes.
7. Refill reservoir with cool, clean, tap water.
8. Repeat steps 2, 3 & 4.

User Replaceable Parts

Page 12
Drip Tray
Part # 92649
Stainless Steel
Drip Tray Grid
Part # 92668
Reservoir
Pour-Over
Cover
Part # 92547
Pod Holder Assemblies
Part # 92540: Regular Coffee
Part # 92639: Flavored Coffee
Part # 92640: Tea
Part # 92641: Water
Inlet Valve Flare
to Swivel Fitting
Part # 92498
Inlet Valve Cap
Part # 92638
Commercial / OCS Pod Brewer