Table of Contents
Advertisement
Step 2
As it is shown in Figure 5-3, Connect the composition cable and then put the cable into the hole
you just dug. Push the in-ceiling bracket and dome body to the hole you just dug, twist the set
screw to tighten the hanging board firmly.
Step 3
As it is shown in Figure 5-4, use three screws to fix the in-ceiling decoration enclosure
component on the in-ceiling bracket components and tighten them firmly. See Figure 5-5.
Figure 5-2
Figure 5-3
17
Advertisement
Table of Contents
Need help?
Do you have a question about the SD42C Series and is the answer not in the manual?