Proper Use And Functions - WAGNER Procoat 9185G Owner's Manual

Proper use
and functions
Start
Capability:
Sprays a variety of paints (oil-based and
latex), primers, stains, preservatives and other
nonabrasive materials.
Do not use. . .
This pump should not be used with textured
materials, block filler, asphalt sealer or
materials containing HHC. See coating supplier
if flash point is not listed on the container
Safety features:
Spray gun trigger lock and pressure diffuser;
built-in tip safety guard; PRIME/SPRAY knob
for safe pressure release.
Specifications:
Power .................................Ruitao 37.7 cc
engine, 1.6 Hp
Gas capacity .......................0.65 l
(approximately 1
hour spraying time)
Oil capacity .........................0.08 l
Maximum pressure .............3000 PSI
Flow rate .............................0.33 gal/min (1.25 l)
Max tip size.........................0.017"
Burn hazard. When collapsed,
the cart handle is very close to
the exhaust port of the engine,
which can be very hot after
use. It is recommended that
the cart handle NOT be
collapsed until after the engine
has cooled.
PRIME/SPRAY knob:
The PRIME/SPRAY knob directs
SPRAY
material to the material return
tube when set to PRIME or to
spray hose when set to SPRAY.
Spray hose:
The spray hose connects the
spray gun to the pump.
Spray gun:
The spray gun controls the
delivery of the material being
pumped.
AutoOiler:
The AutoOiler is designed to
provide lubrication to the fluid
section of the pump.
Sureflo Valve:
The Sureflo Valve is designed
to keep the inlet valve open and
from sticking to dried materials.
The Sureflo Valve is activated
manually by the user.
Collapsible handle:
The cart handle can be collapsed
for easier storage.
Turn the cart knobs counter-
clockwise to unlock the handle.
Turn the cart knobs clockwise to
lock the handle into place.
5
Controls and Functions
WIDE
GS-07
(b)
(a)
DirectLink™:
Spraying pressure is determined
by the motor throttle. The throttle
is regulated by adjusting the
DirectLink™ pressure control
knob. The higher the throttle, the
higher the spraying pressure.
VersaTip spray tip:
The VersaTip spray tip can be
adjusted based on your spraying
needs.
Trigger lock:
Engage the trigger lock whenever
the gun is not in use.
GS-07 - The gun is locked
when the trigger lock is at a
90º angle (perpendicular to the
trigger in either direction).
Suction tube (a):
The suction tube draws the fluid
from the original container into
the pump.
Material return tube (b):
Fluid is sent out through the
return tube and back into the
original container when the
PRIME/SPRAY knob is in the
PRIME position.
English