Getting Material To Flow - WAGNER Procoat 9185G Owner's Manual

3. Getting
Material to
Flow
Start
You will need:
• Waste bucket
• Scrap material / cardboard
• Drop cloths to protect floors and
furnishings from overspray
ImPOR´TANT: When placed on a smooth
surface, the vibration of the running engine
may cause the unit to move forward or
backward slightly. Avoid placing the unit on
an inclinded surface or near a drop-off such
as stairs. Block the wheels to prevent the
unit from moving.
5
5. Thread the spray tip guard
assembly onto the gun.
Tighten by hand.
1
1. Start the engine (see page
4). Point the spray gun into
a separate waste container.
Unlock the spray gun trigger.
Squeeze and hold trigger
for steps 2-3.
6
OR
6. Rotate spray tip forward to one of the
SPRAY positions.
Unlock the spray gun trigger.
2 3
SPRAY
2. Turn the PRIME/SPRAY
3. Continue to squeeze
knob to SPRAY.
trigger until the material
is flowing freely through
the spray gun.
7
SPRAY
7. Start the engine (see
directions on page 4).
Turn the PRIME/SPRAY
knob to SPRAY.
9
4
4. Peform the Pressure
Relief Procedure,
page 7.
8
SPRAY
8. Point the spray gun at a piece of
scrap material/cardboard.
Pull the trigger and practice spraying
(see pages 10-11).
English