Lutron Electronics Energi Savr Node Quick Start Manual

energi Savr Node
Quick-Start Guide
System example
Wire Type 1
EcoSystem
®
Energi Savr Node
(QSN-2ECO-S,
QSN-1ECO-S) or
ESN Programming
Interface
(QSE-CI-AP-D)
overview
The Energi Savr Node Wireless Setup Kit (C-ESN-SETUP) contains the following items:
• A pple iPod touch device preloaded with Lutron
on the Apple App Store)
• W all charger for iPod touch
• 8 02.11g wireless router preconfigured to communicate with both iPod touch device and Lutron
Energi Savr Node units
• E thernet cable for connecting wireless router to Energi Savr Node system

Getting Started

Step 1: Wire connections
1.1 Connect one end of the supplied Ethernet cable to an
EcoSystem Energi Savr Node unit (QSN-1ECO-S,
®
QSN-2ECO-S) or to an Energi Savr Node Ethernet
Programming Interface (QSE-CI-AP-D).
Note: If more than one QS link is present, these steps
will need to be repeated for each QS link.
1.2 Connect the other end of the supplied Ethernet cable to
one of the standard LAN ports on the wireless router. Do
not plug the cable into the WAN (Internet) port.
1.3 Connect the supplied router power supply to the router
and plug the power supply into a wall outlet. Verify that the
wireless router is powered on by confirming that the lights
on the front of the unit are on.
®
™
Energi Savr Node
Unit
QS Link
Wire Type 2
Wireless
Router
Wireless Setup Kit
Apple iPod
touch
To Power
Outlet
Energi Savr Node setup application (also available
®
Note: The wireless router has already been configured
to communicate with the Apple iPod touch device. If
you restore the router to its factory default, you will
need to re-establish wireless communications between
the Apple iPod touch device and the router using the
Apple iPod touch device's WiFi connection screen.
Step 2: Discover the system
2.1 Remove the Apple iPod touch device from the packaging
and power on the device by holding the button on the top
of the unit for several seconds (until the screen becomes
active). Allow some time for the device to boot up.
Note: You may find that the Apple iPod touch device
is not fully charged. If necessary, connect the supplied
Apple iPod touch device wall charger
to a power source and then plug the
Apple iPod touch device into the
wall charger.
QSM
Wire Type 1
Wire type and corresponding maximum wire distance:
Type 1 Lutron GRX-CBL-346S cable:
Lutron GRX-CBL-46L cable:
Type 2 Standard CAT5/CAT5E cable:
100 ft (30 m) cable included with kit.
NOTE: Total wire length not to exceed maximum wire distance shown above.
500 ft (152 m)
2000 ft (610 m)
300 ft (91 m).