Changing The Position Of The Operation Panel; Installing The Thread Stand - JUKI MS-1261A-DWS Instruction Manual

2-1-2. Changing the position of the operation panel

The operation panel has been installed on the undersurface of the sewing machine table at the time of deliv-
ery. When you install it on the top surface of the sewing machine table, it is necessary to pass panel cord ❶
through hole ❸ in the lower section of motor cover ❷ .
At the time of shipment
(undersurface of the sewing machine table)

2-2. Installing the thread stand

❸
❷
❸
❶
In the case of changing the position of the operation
panel to the top surface of the sewing machine table
1) Assemble the thread stand device. Fit it
in the hole in the table. Tighten locknut
❶ so that the thread stand does not fluc-
tuate.
2) Fix thread stand bracket ❷ on the table
with wood screw ❸ .
❷
– 3 –
❷
❸
❶