Table of Contents
Advertisement
No.
Item name
Number of stitches
S042
at which the chain-off
thread cutter is actuated
after the detection of
absence of material
Selection of chain-off
S043
thread cutter operation
by a depress on the back
part of pedal
S051
Needle bar stop position
Limit to the sewing speed
S052
to be applied after the
* 1
detection of absence of
material
Needle-cooler ON delay
S053
number of stitches
Part number
S061
Process
S062
Comment
S063
Number of stitches at
S068
which the cloth puller
starts running on the
multi-layered section
Number of stitches during
S069
which the cloth puller
runs on the multi-layered
section
Cloth pulling amount
S070
when the cloth puller
runs on the multi-layered
section
Cloth puller pressure
S071
when the cloth puller
*3
runs on the multi-layered
section
Cloth pulling amount
S072
when detecting no mate-
rial
*1: The actual sewing speed is limited by "S003 Stitch length" and the set value of cloth pulling amount.
In the case the set value of stitch length is 3.1 mm or more: Maximum sewing speed 5000 sti/min
In the case the set value of cloth pulling amount is 4.6 mm or more: Maximum sewing speed 4000 sti/min
*2: If this value is set to a negative value (minus value), the presser foot will go up. If the presser foot height is set so
that it floats, the multi-layered section changeover function will be disabled.
*3: If this value is set to a negative value (minus value), the cloth puller will go up.
Input range
This data item is used for setting the number of stitches
0 to 2000 stitches
to be sewn before actuating the chain-off thread cutter
after the detection of the absence of material.
This data item is used for selecting the operation of the
Operate / Not operate
chain-off thread cutter when the back part of pedal is
depressed to the second level.
Stop at the
-
upper posi-
tion
Stop at
the lower
position
This data item is used for setting the sewing speed to be
150 to 5500sti/min
employed when the absence of material is detected.
This data item is used for setting the number of stitches
0 to 200 stitches
to be sewn from the time at which the sewing machine is
started to the time at which the needle cooler is actuat-
ed.
0 - 24 characters
0 - 24 characters
0 - 50 characters
This data item is used for setting the number of stitch-
0 to 200
-
es to be sewn from the time at which the multi-layered
stitches
section of material is detected to the time at which the
multi-layered section is brought to the cloth puller.
This data item is used for setting the number of stitches
0 to 200
-
to be sewn while the cloth puller runs on the multi-lay-
stitches
ered section of material.
This data item is used for setting the cloth pulling amount
1.2 to
-
to be used while the cloth puller runs on the multi-lay-
5.5mm
ered section of material.
–90 to 120
This data item is used for setting the cloth puller pres-
-
sure to be applied while the cloth puller runs on the
multi-layered section of material.
1.2 to 5.5mm
– 41 –
Advertisement
Table of Contents
