Airstream Caravanner 1977 Owner's Manual page 69

Fig. 3 — AM/FM Radio Fuse
DISTANT and pull out for LOCAL to
achieve optimum FM reception.
5. Adjust VOLUME control to desired
listening level.
6. Adjust TONE control for desired bass
or treble response,
7. Adjust FADER control for desired
sound level between front and rear
speakers.
8. Adjust BALANCE control for desired
balance between left and right
channels.
9. To switch radio off, turn ON-OFF knob
to extreme left.
To operate the 8 track stereo tape:
1. Switch power on at SELECT-VOL
control.
2. Turn tape player on by inserting the 8
track cartridge into the tape slot; insert
cartridge open end first, label side up,
until it is firmly seated in mechanism.
3. Adjust VOLUME, TONE, FADER and
BALANCE controls.
4. Change programs as desired by
pushing SELECT-VOL control. Each
time the selector is pushed and
released, the next program will play.
Programs will play in succession
(change automatically), and
continuously, if manual SELECT is not
pushed. The tape program indicator
lights will light, indicating which
program is being played.
5. To switch tape player off and radio on,
pull cartridge out approximately one
inch from its seated position or remove
it entirely. Never leave a cartridge in
the tape slot when player is not in use.
Fig. 4 —Air Conditioner Ducts and Filter
Store tapes in a cool area with open
end down. Protect tapes from dust and
direct sunlight.
In time, oxide from recording tape will
accumulate on the tape head and capstan
shaft which can cause tape hiss and erratic
operation. The more often the tape player is
used, the more often it should be cleaned.
Clean the head with a cotton swab
moistened with isopropyl alcohol,
Do not
use carbon tetrachloride.
To clean the capstan shaft, first turn on the
motor by depressing the motor switch (next
to the capstan shaft) with the eraser end of
a pencil. Use a cotton swab moistened with
alcohol on the shaft.
The fuse for the radio, or radio/tape is
located behind the unit. To gain access to
the fuse, release the latch located on the
back of the stereo unit cabinet and let unit
hinge down. The fuse is secured with an
inline fuse holder. (See Fig. 3.)
The
Armstrong air conditioner
can be
used for cooling or heating your trailer or
for air circulation only.
To operate for cooling:
1. Close doors, windows and ventilator.
2. Set wall thermostat to "COOL" position
and set thermostat indicator to your
desired comfort level,
3. Set system switch (located at ceiling
cover of air conditioner) to your preferred
speed setting
59